|
Message
From: Gustaw47@p...
Date: Tue, 18 Mar 2003 13:07:43 -0100
Subject: [pci] Please help me with PCI - CRT Test Application
Hello
I am trying to run PCI test application on my prototype board.
I use Xilinx ISE 4.1 and FPGA EXPRESS, on device XC2S150-208-6.
Project is succesfully built and .mcs bit-stream is generated, Timing
constraits and PIN locations are OK, Spartan loads and starts-up.
The problem is, that during a computer's boot, bios doesn't see my PCI
card. On listing it shows different Vendor/Device rows, but there is no
my card.
Is this a correct behaviour ? Should BIOS show pci crt dev/vendor on
list ?
Maybe I should change something in pci_user_constraints ?
Can somebody provide me a working Xilinx .npl project file, because I am
not shure, if my settings are OK ?
Thanks in advance
Gustaw Mazurek
|
 |
Browse
