|
Message
From: John Sheahan <jrsheahan@o...>
Date: Wed, 16 Apr 2003 08:17:36 +1000
Subject: Re: [oc] UART16550
try changing labview to use 2 stop bits if possible. This may help
verify the exact problem.
certainly the uart should start looking for a start bit just after
the midpoint of the first stop bit, (to allow for baud rate mismatch)
when running in single stop bit mode.
john
On Tue, Apr 15, 2003 at 03:25:14PM -0100, tate@a... wrote:
> Hello all,
>
> I've just compeleted my first UART16550 core instantiation and have run
> into a problem. I'm setup to run at 57.6k and the core performs
> perfectly for individual characters received. However, if I chain to
> bytes back to back (from a labview application running on win98) I
> sometimes loose the second byte.
>
> Reviewing the source code I notice the receiver statemachine goes to
> a "stop" state that detects the stop bit and then counts down... This
> count down causes me to miss the next startbit of the second byte...
>
> Has anyone else seen this problem?
>
> Thanks,
> Steve
>
|
 |
Browse
